Farmall & IHC Tractors Discussion Board |
Re: Steering housing leak
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Roger46 on January 03, 2006 at 18:40:30 from (69.58.138.68):
In Reply to: Steering housing leak posted by Tyler in SD on January 03, 2006 at 07:19:12:
Tyler, I am restoring a Farmall Cub right now. Last Friday I just put mine back together. First you need to block up the front of the tractor as this is the wide front mount. I think it is best if you remove the wide front, although you may be able to do it without removal. There are five bolts that hold the whole assembly together. There is a locating pin that can give you trouble getting this lower unit out. The whole unit then drops out the bottom including the steering gear. You might want to replace the steering shaft seal while you have it apart as this is another leak source. If you do that, I would rotate the steering gear 180 degrees to get new teeth meshing with the steering worm gear for reduced steering wheel play. Then you can clean off the old gasket and put on a new one. The local Case IH/NH dealer had a gasket in stock for me. Again, basically that lower steering unit just slips in from the bottom. Roger
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|