Farmall & IHC Tractors Discussion Board |
Help on gas start diesel Please
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kevin Cooke on January 02, 2006 at 16:09:40 from (24.236.223.27):
I need to talk to someone who knows their stuff about 600 650's. My 600 sounds unsmoothand has a small amount of smoke. I rebuilt the injectors($), checked the compression the best I could checked for leaking start valves. Every move made a small improvement but its still not right. When I had the injectors out I noticed that the precups werent installed in the same way in each hole. This is a WD9 head so it has the older injector that comes out easily but how do I get the body and the precups out and willo it make any difference. Also I can determine which cyl is causing the smoke by cracking the bleeder. Any help is appreciated. thanks
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|