Farmall & IHC Tractors Discussion Board |
Re: Farmall 140 wheel slippage
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on December 29, 2005 at 15:06:53 from (24.93.8.168):
In Reply to: Re: Farmall 140 wheel slippage posted by cajungreek on December 29, 2005 at 10:24:36:
This is the normal operation of a standard differential. The power will always transfer to the wheel with the least resistance. To compensate, tap or hold the brake of the spinning wheel to transfer power to the other wheel. Your 8N may have a crude "limited slip" differential that explains why it behaves the way it does. IH didn"t have such a device back then, especially on its smaller tractors. Now, you can add weight to improve traction, but BE CAREFUL here. If the implement you"re pulling is too much for the tractor, adding weight will only break the tractor when it grabs, but the implement still won"t go.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|