Farmall & IHC Tractors Discussion Board |
Re: Rear wheel seal on 350
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan in NE on December 28, 2005 at 04:02:48 from (148.78.243.26):
In Reply to: Rear wheel seal on 350 posted by 350 HU Don on December 27, 2005 at 19:14:17:
Don, When I was a boy, I grew up movin' and changin' IH wheels as many as 6 times a season on four tractors because we used different configurations of the same tractor on different tasks on the farm. As such, I've learned quite a few little tricks and shortcuts over the years on how to handle these buggers. Plus I've got some special tools that I use to make quick work out of this nasty job. However, I gotta agree with John D on this one! If you aren't used to wrestlin' these rascals, don't do it like I do because they are very, very heavy, they are totally lop-sided weight and if you don't know how to handle them and if you don't know how to make 'em "walk and talk", they will get away from ya and things will go wrong in a big way. The correct way is to block up that rear end with some bridge planking to make sure the tractor is secure and then use a crane or loader of some sort to remove the wheel/rim/tire. Even then, you've really got to be careful! Use a wire brush or some such thing to clean the axle, then give it a good bath of engine oil before putting on the new seal. Biggest risk is cutting that new seal on the lip of the axle groove. Don't forget to replace the o-ring in the retainer as well. I've got to replace my front end pivot bolster, but I'm not even gonna show you guys how I do that. I'd probably have heart attacks poppin' up all over the country! :>) Allan
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|