Farmall & IHC Tractors Discussion Board |
speed sleeve for an h axle update
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by tn terry t on December 26, 2005 at 18:26:48 from (205.188.117.73):
upon further inspection i found the real culprit its the bearing cap that made the groves in the axle both bearing are shot as in the bearing cage is gone! i have new national seals that are the same size as the old c/r seals number is 415001 which O'reilys call ag seal. they also gave me the number of 455001 as a normal automotive seal which is thiner like you guys where telling me. i dont think using the thin seals will work because where the two wear spots are. talked to the machine shop foreman at work about it he said that they send out shafts now to be "spray welded" and then turned back down to spec. they have welded up a 1000 ton press crank shaft plus many others he seems to think that would be my best route whay you guys think of that?
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|