Farmall & IHC Tractors Discussion Board |
Re: anybody ever try this?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Spence on December 26, 2005 at 13:29:49 from (216.209.139.90):
In Reply to: anybody ever try this? posted by john koritansky on December 26, 2005 at 05:48:45:
If what you are trying to do is get your 3PH to operate a driving cylinder, then it would work. Issues to be considered are the force applied will be much greater than what the pump is applying. In other words if it puts out 1500-2100 lbs, the driven cylinder(3PH) is working at a much higher force than the pump, so the plumbing and cylinders of the independant system would need to withstand the force of the working pressure of the 3PH. Another is the driven cylinder travel of the new system would be much less than what is supplied by the 3PH, given a standard arc travel of 20-30 inches.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|