Farmall & IHC Tractors Discussion Board |
Re: Got the starter for my 706
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MN Scott on December 24, 2005 at 17:20:23 from (206.9.216.87):
In Reply to: Got the starter for my 706 posted by Kelly C on December 24, 2005 at 16:00:32:
This summer I needed a set of roller bearings for the bull brake pinion on my 756. I priced them at CNH for $32 per bearing and race combo. Napa wanted $50 for the same thing and Greed Deere quoted $67! It always pays to check with the dealer first. Is that the 706 your going to overhaul? I got started on my 706 today it has a knock when cold that used to go away when she warmed up but not any more. Had about 600 easy hours on a dealer overhaul unrolling hay for cattle. Not liking what I'am finding, no6 is lightly scored and two others have up and down wear pattern. Not sure what I'am going to do yet, replace one sleeve piston assembly and send it on its way or fix it right and keep it.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|