Farmall & IHC Tractors Discussion Board |
Re: 1466 another question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Weldon on December 21, 2005 at 19:08:47 from (71.28.65.125):
In Reply to: Re: 1466 another question posted by SGT K on December 21, 2005 at 05:30:50:
In the photo you entitled "Gear Teeth in the transmission" the piece near the left side of the photo is a part of a detent roller not a gear tooth. Without the detent roller, shift linkage feels loose and does not " snap " when going into or coming out of High, Low and Reverse. Not difficult to replace the roller. The photo is not quite clear enough to identify the other two pieces . ( However I think that they are the other pieces of the detent roller). If you have a pronounced "click" when you are in reverse, then they are teeth off the reverse gear where the park lock pawl has chipped them off.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|