Farmall & IHC Tractors Discussion Board |
Re: removing the crankshaft pulley on Super C
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on December 13, 2005 at 04:08:24 from (152.163.101.13):
In Reply to: Re: removing the crankshaft pulley on Super C posted by Bob the billder on December 12, 2005 at 18:47:02:
If you have a cutting torch you can make one pretty quick. You can get the 3/4 allthread from Home Depot. Get the 36" and have them saw it in half. They have the flat washers and the hex nuts. When you get ready to reinstall the pulley, place it in your over at 225 degrees and let it get thoroughly hot. Use your welder's gloves to handle it. Be sure to clean the crankshaft where this pulley is installed too. You need to have the bolts on the timing gear cover loose until you get the pulley installed. You need to inspect the hub on the pulley to make sure it doesn't have a groove worn from the old oil seal. If it does Chicago-Rawhide has speedi sleeves and seals to repair this problem. Hal
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|