Farmall & IHC Tractors Discussion Board |
Re: SC Just release bearing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by farmallhal on December 09, 2005 at 12:53:49 from (64.24.35.17):
In Reply to: SC Just release bearing posted by Keith-OR on December 09, 2005 at 09:29:37:
Thanks Keith for the info. I checked my parts catalog and part no. 361292R91 is one of three optional bearings listed for tractors equipped with a hydra-creeper attachment. The other two are 18567D and 55212D. You should take the old bearing and retainer with you to be sure you are getting the right part. The part catalog doesn't show just a bearing for tractors without the hydra-creeper attachment just the retainer assembly which contains the bearing. I hope this is in fact correct as it would certainly be less expensive. Good luck and let us know. Hal
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|