Farmall & IHC Tractors Discussion Board |
Re: Re-Converting Alternator to Generator?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by pete7 on December 09, 2005 at 06:03:01 from (205.188.117.73):
In Reply to: Re-Converting Alternator to Generator? posted by David Kronwall on December 09, 2005 at 03:53:45:
Hi David....I find alternators to be more reliable. Generators need a voltage regulator and the regulator uses points, not solid state type electronics. Points are just far less reliable than a modern electronic regulator that is built into the alt. I changed from a generator to a alt (on a Super A) and it was the best thing I did on that tractor. It's started perfect ever since but when it had the generator, I always had to hold my breath and hope (and I was often disappointed!). Pete
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|