Farmall & IHC Tractors Discussion Board |
Re: 1486 no forward gear
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JJK on December 04, 2005 at 14:36:27 from (216.189.131.29):
In Reply to: 1486 no forward gear posted by natedoggmotorhead on December 04, 2005 at 09:36:22:
The special tool the tractor vet mentioned is one part is used to push down on the reverse shaft as you lift the cover so that the half moon key don't fall out from down below. That ain't the biggest deal in the process but I'm sure you don't want to monkey with the fuel tank just to get to the side cover. When it goes back together you need the second part of the tool kit to hold the detent arms and spring in place as you put the cover back on. This part is probobly impossible without the tool. Don't fret if you see that you need a fork or rail, just remove the retaining clip on the rail and slide it back to replace the fork and the rail can be installed from the hole behind the top link cover with a long reach. Also rebuild the shift cover as long as its off because it probobly needs to be done anyway.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|