Farmall & IHC Tractors Discussion Board |
Re: no steering on cold startup
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JJK on December 02, 2005 at 19:20:35 from (216.189.131.91):
In Reply to: no steering on cold startup posted by skip on December 02, 2005 at 17:58:17:
You can try to change the hyd. filter first to see if it helps but I have a feeling that the pump is getting weak because it shouldn't have any trouble running at 30 or even 10 degree's. Might be a little stiff but should still work. I hope the reman pump is right from Case IH and not an aftermarket. I've had the best luck with those than anything else. I also suggest completely going through the MCV if you put a new pump on just to make sure the spools aren't hanging up and any junk that can be floating in the system is cleaned out. Also if the pump doesn't prime up after repair you can remove the 5/8 hex plug on the right side of the MCV,(little messy) start tractor up and shut off as soon as oil shoots out, and make sure you keep out of the way of the oil spray. Install plug and your good to go.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|