Farmall & IHC Tractors Discussion Board |
HELP! M won't start after installing voltage reg.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Granger on November 27, 2005 at 11:11:24 from (67.1.233.239):
A couple of weeks ago (after I used Bob M.'s trouble shooting guide) & discovered that I had a bad voltage regulator, I ordered a new one & replaced it. After I replaced it,I jumpered between the "BAT" & "GEN" terminals at regulator & started. It started right up & I let it run for a while & the ammeter showed a charge, which it did not before. Well, I went to start it today & at first it started right up & then after a little while, it died on me. When I went to start it again, it was DEAD. I turned on the lights & it still shows a discharge, but when I push on the starter, NOTHING happens. Any ideas out there was is happening or I should check? Thanks for all the help.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|