Farmall & IHC Tractors Discussion Board |
Re: International A110 Pickup truck
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Buzzman72 on November 27, 2005 at 09:06:07 from (207.69.139.147):
In Reply to: International A110 Pickup truck posted by Nebraska Cowman on November 27, 2005 at 06:45:31:
At the VERY least, I'd be looking for a 120 [3/4 ton] or 130 [1 ton] frame with the same wheelbase to set the body on...OR I'd be boxing that frame before swapping the 'Stroker motor in. IH sixes were around 750 lbs, vs. probably 900+ for the powerstroke, so plan accordingly. If you box the frame, you can probably go to some springs off a 120 or 130 series, and you'll be OK...the IH corporate rear end was pretty stout, but if in doubt, swap in a Dana 60 with 8-lug pattern from a 3/4 Ford or Dodge--not sure what you'd have to swap in to make the front hubs compatible, probably a trial-and error thing there, or a front straight axle from a '69-up International might work. Then you'd have an A-series BinderTruck to be proud of! Try the Harmon Glass website for the windshield.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|