Farmall & IHC Tractors Discussion Board |
Re: Splitting a Supre C for clutch plate removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on November 26, 2005 at 16:41:51 from (209.226.247.174):
In Reply to: Splitting a Supre C for clutch plate removal posted by streaker on November 26, 2005 at 15:59:32:
streaker: I use a 4" channel iron frame, shaped in a U under pan, with wood pads going against pan bolts and block. The pan will actually carry the weight of engine, but I don't like doing that. I then put in wedges so engine can not tip in relation to front axle. With a narrow front I remove front wheels. I put a good hardwood pallet on floor then block up securly to front end. I then put tiedown ratchet straps over engine securing it solidly to the blocking and pallet. I then put a bottle jack under clutch housing and a pallet jack in pallet and jack the two in unison. It will roll right apart, and this gives you absolute control of that front end. Remember to lock brakes and chock rear wheels. I have used this system on tactors as large as 560D for changing clutches. Makes it a one man job. I also split an articulated Deere at the articulation point using this system. Only difference doing this I blocked the front end and put pallet and jack under rear end. I have removed 20.8x38 complete rear wheels strapped in standing position to the pallet. I wouldn't be without my pallet jack. You can have more than one job on the go, just needs more hardwood pallets.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|