|
Farmall Tractors Discussion Board |
Re: Re: Re: Re: Re: DT466 from a cabover.. what (Besides a Zetor) will it fit?
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by matt hoscheit on December 30, 1999 at 15:49:43 from (204.73.44.124):
In Reply to: Re: Re: Re: Re: DT466 from a cabover.. what (Besides a Zetor) will it fit? posted by RickB. on December 30, 1999 at 15:17:40:
we use that 466 eng in alot of ag like was said of the 66 86 88 series ih you will have to cgange your front timing cover but not likely the plate that saves having to take out the camshaft out and don't worry about the oiling that is the same set up that tractor pullers run up to5000rpm and have no problems the combine does use the ag front timing cover but the rear is defferent that is were they put the starter the pan and pickup is also different and a combine dip stick is in the pan but the block has all that is needed to switch don't worry about the power any one with a dyno can lower the fuel detting and give you great service good luck you have a good motor there find it a good home
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
