Farmall & IHC Tractors Discussion Board |
Re: IHC 986
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by chadd on November 09, 2005 at 06:16:01 from (155.92.196.178):
In Reply to: Re: IHC 986 posted by Don Anderson on November 08, 2005 at 09:52:02:
I don't have the factory service manual. I just have a cheap IT manual that can be bought just about anywhere. It covers the 74 series, 66 series, and 86 series. It would probably be easier to just buy the manual than to photocopy it. I doubt it has the detail of a factory service manual, but it only cost 10 or 15 bucks. The Multiple Control Valve is located on the right side of the tractor when sitting on the seat, just back from the clutch. It will look like a squared off panel with probably 18 or so bolts holding it on. Inside this panel are several valves, passages, o-rings, and springs to make all of the tractor functions work correctly. When this whole panel is removed, the pump will be bolted on the back of it. This is all based on a 66 series and older tractor. The 86's should be similar, but I am not sure.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|