Farmall & IHC Tractors Discussion Board |
Re: RE: 434 IH Starting
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by AL Sproule on November 08, 2005 at 15:53:36 from (206.172.223.43):
In Reply to: Re: RE: 434 IH Starting posted by Tim...Ok on November 08, 2005 at 15:21:51:
Well I thought for sure after your last post Hal it was the solenoid. I checked for voltage and there was none. After swapping out the old one and put in the new tried it again and still nothing The tractor has a key start and only one wire comes off the small "S" terminal the other has nothing. Would the wire form the small terminal feed the igntion switch? Maybe another cleaning might be in order, although the area was bright and shinny from when it was replaced last year LOL. Would the positve ground have anything to do with it? Maybe the guy's who fixed it did not know about it.. Thanks again guy's AL
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|