Farmall & IHC Tractors Discussion Board |
Re: Oops. Now I did it. M question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on November 07, 2005 at 19:24:15 from (12.65.72.5):
In Reply to: Oops. Now I did it. M question posted by e-manhunt on November 07, 2005 at 18:09:55:
As Jani said, you have likely tried to remove the hydraulic (Lift All) unit to get at the lost bolt. That unit is very heavy and the drive connection to the transmission as well as the pipe connections and the control connection on the side has to be removed to get it out. It is held in by four 3/8 inch bolts. If you decide to remove it, make sure you have help and do not drop it on any of your body parts, as it weighs more than 100 lbs. I also, do not agree that the bolt will do no harm. I don't think there is room between the ring gear and the housing to clear a bolt of the size (1/2 inch??) that holds on the starter. It's gonna get wedged between and something will be damaged. I think the magnet suggestion is a good start. Beyond that, I don't see much option except to drop the lift all unit. I'll take a look at mine tomorrow and see if there is an inspection hole I've forgotten about.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|