Farmall Tractors Discussion Board |
Re: Re: Re: Touch Control Fluid ?
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Farmer Bob on December 28, 1999 at 20:51:26 from (207.227.187.232):
In Reply to: Re: Re: Touch Control Fluid ? posted by Stan on December 28, 1999 at 20:18:17:
Stan, Collapsed is the same as retracted, closed. Just make sure the ram is fully retracted and I believe that's all the way toward the seat if it is like the one on a Cub. This allows all the fluid to go back into the reservior from the ram so you get nearly a complete change of oil. As Phil mentioned about metal pieces in the old fluid, when I change oil in any thing I let the stream of used oil flow over a large speaker magnet which sits on the screen at the top of my oil drain pan. After the oil drains off of this magnet I check for shavings, slivers of metal or any other unusual debris. You can sure be forwarned of possible future catastrophic failures using this trick. Good luck. FB
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|