Farmall & IHC Tractors Discussion Board |
Re: 90 weight leak
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on October 13, 2005 at 16:10:21 from (24.235.41.226):
In Reply to: 90 weight leak posted by Joe 44H on October 13, 2005 at 14:10:49:
Joe, that is what we refer to as the "belly pan" You likely have a leak at the driveshaft seal or the drive for the "belly pump", the hydraulic pump. Either of these seals are easy to change. If you have hydraulics then it is more of a job, you have to take the pump out first. There are three bolts at either end of the drive shaft, remove the drive shaft and you can get at the seal. You unscrew the flange, then carefully pick out the old seal and tap in a new one. The new I-H seals are about half as wide as the original but are made of polyethelene base and will do the job. A small block of wood is good to tap the new seal into place. The same applies to the pump drive seal if it is leaking, then reassemble everything. Its not an impossible job, sometimes getting the old seals out is nerve wracking. I find the most success with picking chisels and punch. I try to get a punch in between the seal and the wall of the transmission and collapse the seal that way and then pull with needle nose pliers. Get a Blue Ribbon Service Training manual, it pretty much explains the process, but as I said its not a bad job except if you have a hydraulic pump...good luck, ask if you need help and lots of guys here will help you...Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|