Farmall & IHC Tractors Discussion Board |
SA implement painting
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scott#2 on October 12, 2005 at 17:20:58 from (141.156.141.93):
I bought this sa a while back and have started the tractor restoration part. Lots of thanks to all that have helped me along the way, CNKS, Rod, Paul and all others . Hopefully I can finish it off this winter as everything is about ready to be reassembled, another week or 2 on the tin. I was wondering what might be the easiest way to clean and paint the implements. I've got a double plow, full cultivators, mid mount sickle bar mower, side planter/dresser and a front blade. The thought of wheeling these pieces to steel before priming makes me cringe. Does any one have a better idea short of dipping or wholesale sandblasting, like at a ship yard or somewhere? I was wondering about these "rust converter paints" that I read about here. Has anyone tried them on rusted implements and if so, how are they holding up? I posted in implements too. Thank You, scott#2
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|