Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Where do you stop??


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Janicholson on October 10, 2005 at 19:49:48 from (66.173.50.76):

In Reply to: Re: Where do you stop?? posted by P and R Pete on October 10, 2005 at 18:35:46:

Timing can have a very minor impact on running on.
When the ignition is shut off the spark plugs stop sparking, thus timing is not happening.

However---if the timing is set retarded so much, or advanced so much that the tractor heats badley from being way off, then the heating will over heat the spark plugs, valve edges, and combustion chamber edges to the point that they become incandescent (glow red). This destructive condition can lead to Running on because the glowing parts set the mixture on fire as the piston comes up. making as if to go on forever.

Most farmalls will run on to one degree or another if shut off from a hard full effort workout with out a few minutes cooldown. (the fuel solenoid on newer tractors stopped this by stopping fuel.

I'd bet yours is carboned up in the combustion chambers from running rich. This has two issues. One, the compression is much higher than normal from the deposits, creating extra heat. And two, the carbon is a great source of glowing igniter. The solutions are two. Run it and clean it by operating correctly (listen for pinging and you might need to run medium octane fuel till it clears the carbon). Or, remove the carbon (many theories on adding various fluids while it is running --I do not subscribe to them--) and or remove the head and wire brush the devil out of it. with a 1" wire cup in a drill. (wear a respirator to do this because the material will be lead contamination and that is not good for you.
Great letting you in on what I know. JimN


Follow Ups:




Post a Followup

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy