Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: How to clean tank


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by PaulW_NJ on September 29, 2005 at 21:00:08 from (70.111.79.24):

In Reply to: How to clean tank posted by DigDugNC on September 29, 2005 at 08:52:12:

The tank on my 340U was badly coated with old smelly gas residue, and thick rust granules when I bought it. I first filled it with hot water and detergent to remove any oil coating. I"m not sure how much that accomplished.

Next, after draining all of the water from the tank, I put in a gallon of full strength muriatic acid that I bought at an Ace hardware store - same stuff used to clean cement off of brick, etc. I rotated the tank to make sure each side was immersed for at least 10 minutes, two times. When I poured the acid out, it was an extremely dark orange color. I flushed the tank several times with water, and then hooked my shop vac to the tank inlet with duct tape (I opened another hole that the gas gauge was connected into) and blew air thru it for 20 minutes to dry it out. The final inside surface was clean, and shiny metal - the residue and rust had dissolved into the acid. I poured a couple of cups of diesel into the tank to coat the surface and hold off rusting until I got some gasoline in there.

I had been given a price by my local radiator repair shop of $120 to do this job. I found in my area, at least, few places clean tanks any more due to safety and environmental concerns. A gallon of muriatic acid cost me less than $10. However, be extremely careful handling it, wear eye and hand protection. It is also safer not to dilute the acid.

The same radiator shop told me he doesn"t do, or recommend coating cleaned tanks - it"s apparently too easy for the coating to lift back off the acidized surface if even the slightest edge is left exposed. He apparently had enough problems that he stopped doing it.


Follow Ups:




Post a Followup

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy