Farmall & IHC Tractors Discussion Board |
Re: changing 3 point hitch on int'l 300U
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Unreserved dick on September 29, 2005 at 08:52:45 from (4.228.126.142):
In Reply to: Re: changing 3 point hitch on int'l 300U posted by ron bond on September 29, 2005 at 04:30:48:
As CNKS said, your solution for use of standard Category 1 3-point equipment is to attach the conversion bars to the equipment FIRST, prop them up parallel to the ground with a 2x4 on top of a cinder block (or whatever else is handy or turns your crank) and then BACK the tractor into them. Hop off and hook up the toplink, and you're ready to go. No cutting or welding is necessary, and it's certainly not desirable. The spacing of the fixed U-shaped hitch was set up to match the standard 26" Category 1 spacing. If the implement you're trying to use doesn't fit, it's not standard Category 1 equipment. Backing the tractor into the adapters beats the heck out of the 3-point system on the old Ford tractors where you end up wrestling with the implement, or the tractor, or both, while trying to get things to line up. If you need the bars for mating the 3-point equipment to the Fast Hitch, follow the link to find one supplier.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|