Farmall & IHC Tractors Discussion Board |
MeaCulpa NFE
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GordoSD on September 11, 2005 at 19:21:42 from (64.68.166.234):
After a lot of help in private email from Hugh we got the WFE to NFE problems sorted out. The Schwartz WFE will not work properly with the extended stop bolt int the bolster mount plate. So there are a lot of those proper bolts for a NFE gathering rust somwhere. After a lot of cleaning and high power light looking. I did finally determine that a 54 SMTA does in fact have the proper casting ridges in the front bolster hole for an extended head bolt, in the right front hole, to work as a stop. It allows about 50 degrees of front wheel travel each way. I didn't try to get the bolt fromIH, just welded a 3/4 inch 5/8 bolt on the 3 inch 3/4 inch bolt, cap to cap, and did a little grinding. All set to mount the NFE if I can get it painted. 35 mph winds for 3 days have kept the spray gun hanging from it's hookeye! I'm gonna part out one Schwartz wfe, any one need rods, spindles etc? GordoSD
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|