Farmall & IHC Tractors Discussion Board |
Re: H brake band adjustment question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave in CT on September 07, 2005 at 14:15:58 from (64.148.61.66):
In Reply to: H brake band adjustment question posted by Bob Frey on September 07, 2005 at 13:51:26:
Had the same problem on one of the brakes on my H, as well. Like you, tried a new band, still unable to get it within any range of operability. Disassembled the unit again and took a close look at the two cam plates the pins that secure the ends of the bands go through. The plates were twisted out of alignment with each other. The brake couldn't possibly have done its job like that. Since then I've heard this is a common problem with the H brakes - sometimes the shaft that the plates are welded to just twists and other times the welds that hold the cams to that shaft break. The first used replacement cam assembly I bought had fine cracks in the welds. When you get it apart, if the cam plates aren't obviously misaligned, clean the cams up good and look for those cracks. I got my replacement from Steel Wheel Ranch but make sure to specify, aligned plates and no cracks in the welds.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|