Farmall & IHC Tractors Discussion Board |
Re: charging system howzit
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John T on September 03, 2005 at 21:04:07 from (66.244.90.98):
In Reply to: charging system howzit posted by holcombwa on September 03, 2005 at 17:36:06:
I cant guarantee on your Voltage Regulator, but on most Ive ever seen that are 4 wire (BAT ARM FLD LOAD) VR's, the terminal on the bottom or off on one side all by itslef is indeed the ARM terminal, especially if the 3 on top are labeled BAT FLD and LOAD No, if you replaced a charging system that only had a 2 wire Cutout Relay and used the light switch for Generator Field Current Control BUT YOU REPLACED IT WITH A FULL FLEDGED 3 OR 4 WIRE VOLTAGE RREGULATOR, the resistors in the light switch which were used for the Generators field current control ARE NOT THEN USED. On 3 brush generators which I convert from 2 wire cutout relays over to Voltage Regulators, I set the Gens 3rd brush to the MAX charge position. John T, retired electrical engineer in Indiana
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|