Farmall & IHC Tractors Discussion Board |
Re: Rear axle bearing replacement on an H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GordoSD on August 09, 2005 at 21:02:04 from (64.68.166.234):
In Reply to: Rear axle bearing replacement on an H posted by Dave in CT on August 08, 2005 at 23:51:28:
Dave, forget about the block between the axles and "pushing the axle out of the housing. You are going to have to have the housing off anyway to replace both bearings. When you have the entire axle assembly off, just hold it up vertical and drop it lightly on a firm surface like a railroad tie. That will knock the bearing out. Turn it over and knock the other one out. DONT beat on the inner axle end where the female threads are. That will cause damage and you will probably have to use a tap to get the bolt started. Guess how I know this? When ready to install, get a good gauge and measure where the bull gear is. Adjust your shim to get that bull gear dead center as you can. Align the splines going in by turning the axle tiny amounts. You can't see it , have to "feel" it Person with arm inside cavity can also turn bull gear a fraction and listen/feel for fit. It's not hard, just finicky, and you will feel great when you feel it all snap into place. Gordo
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|