Farmall & IHC Tractors Discussion Board |
Re: No spark from magneto
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by El Toro on August 03, 2005 at 10:52:58 from (152.163.101.13):
In Reply to: No spark from magneto posted by 26Red on August 03, 2005 at 09:15:12:
The Cowman is probably right on those dirty points, after cleaning them, check that point gap. Should be .013" and then remove the coil wire from the cap and hold within 1/4" of good a clean ground. Have someone crank the engine with the starter and you hold the coil wire. You may want to use a pair of insulated pliers, so you don't get bitten. If you have a good spark your engine should start then. Make sure your mag isn't being grounded, not sure how, but it could be a switch. There has to be a way to shutdown the gas engine and the mag is grounded to do this. Hal
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|