Farmall & IHC Tractors Discussion Board |
Re: M govenor - won't throttle down
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CRUSADER on July 31, 2005 at 07:40:50 from (216.31.5.94):
In Reply to: M govenor - won't throttle down posted by Mels on July 30, 2005 at 17:42:07:
Greetings Mels, No, the govenor does not have to be full of oil, it is lubed and cooled from a line in which is fed from either the crankcase or the head (don't remember exactly which. My Dad went through this a few years ago. He thought he had a bad springs/bushing. He had also removed the carb, and I explained to him that the butterfly's if not positioned correctly would cause him some problems. He ensured me that they were correct. Any way, the govenor assembly was all gummed and mucked up. Get yourself a can of WD 40 (might need one of the BIG cans that is full) and spray the weights, shaft, etc, and everything else in there down real good and work the weights and clean them. This should get your tractor running like it should be and used to real quick. You may also want to change the oil in it soon afterwards. The WD40 will be going into the crankcase, and not sure if this is what you are wanting to run that engine on for long. Hope this is of some help, and Good Luck with your task. Jim
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|