Farmall & IHC Tractors Discussion Board |
Re: Allan - Are the duals on yet?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr.EVIL on July 29, 2005 at 13:21:05 from (216.136.115.250):
In Reply to: Re: Allan - Are the duals on yet? posted by Allan in NE on July 29, 2005 at 10:58:23:
ALLAN - Duals, especially clamp-on type on the older non-wedge-lock IHC wheels should be smaller in dia. than the main tractor wheel/tire. The larger IHC's (1256/1456) with clamp-on cast centers broke the hubs all too frequently the way it was. The smaller tractors like Your 686 never had wedge-locks available. Reason for the smaller duals is to carry less weight on the dual and reduce the off-set force on the center of the cast wheel. Of ALL the factory duals shipped from FARMALL with new tractors less than 1/4 had tires mounted. Used tires would be dualed up with the new tractor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|