Farmall & IHC Tractors Discussion Board |
Re: Lubriplate paint
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on July 09, 2005 at 19:13:22 from (209.226.106.111):
In Reply to: Lubriplate paint posted by MagMan on July 09, 2005 at 17:12:34:
Jon: I'm never without that product. If I listed all the uses here it would take 3 pages of discussion. I first used it on IH cyclo air planter back in 1975. I keep both the spray can as well as the paint can type you brush on. second great use I found for it back in the 70s was spraying or brushing on plow moldboards after a seasons plowing. Stopped the rust build up and soil flowed over it great 1st day of plowing the next year. About two months ago, place where I work had 6 load bars for use in van trailers. These are very similar to the old type bumper jacks. None of these 6 worked. Boss told me to pickup 2 new on in my travels. Now I expect these things cost $50. to $100. each. I picked up a spray can of graphite and within 15 min I had all 6 of the old ones working. Quite economical repair if you ask me. Great around door hinges, locks, latches, tractor hitches like 3 point balls, fast hitch forks, steering shaft bushing near steering wheel on SA, latch that ties brake pedals together,etc. You get the drift, I could go on and on all night, great product. It might make penetrating oil obsolete.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|