Farmall & IHC Tractors Discussion Board |
Re: Farmall H PTO Chatter
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Calif. Farmall on July 05, 2005 at 02:09:59 from (207.200.116.203):
In Reply to: Farmall H PTO Chatter posted by jrodsh on July 04, 2005 at 17:24:13:
Hey - sounds like the shifter is not sliding the coupler all the way onto the splines if it's a basic H pto. It may be bent or binding and the chatter could be the splines engaging and disconnecting. It's a simple setup just make sure you get full engagement. When you start to move the pto shifter , engine off and in 1st gear, turn the pto by hand and feel how far the pto shifter moves before it starts to engage. The shifter shuold move another 50-70 percent farther after it engages, if it only moves a small amount it's not engaging far enough. Also check the shaft that is up in the trans and look at the tip and make sure they are ok.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|