Farmall & IHC Tractors Discussion Board |
W-30 / F-30 carb overhaul question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pete in Holland, MI on July 03, 2005 at 22:13:59 from (24.231.248.86):
In the midst of a carb overhaul and have a couple questions: 1) When reassembling the die-cast venturi into the housing, is there an orientation that must be followed (radially? ) 2) Throttle butterfly plate........How much daylight is too much around the hole ? 3) There's a little brass tube that apparently allows suction of gas from the bowl. Tube appeared to have been criped into the threaded nut portion and was loose. I assume this joint should be tight? 4) Tractor would not idle down where it should prior to the rebuild. Idle screw was fully backed out. Any areas of the carb that may be allowing the engine to run faster that I need to pay attention to ? Thanx......
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|