Farmall & IHC Tractors Discussion Board |
Re: Basic Bodywork Question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Janicholson on June 01, 2005 at 07:03:43 from (199.17.6.175):
In Reply to: Basic Bodywork Question posted by EricB on June 01, 2005 at 05:09:34:
Depending on the surface (rust, loose paint, dings etc)in the new metal, the careful use of sand blasting is ok. Blasting if done to excess can reshape metal, and ruin good parts. Ask a local body shop what they would do to prep your pieces. Stripping using commercial quality stripper from an auto refinishing store works very well on this type of project. Several types are out there so buy small amounts and try them one at a time to see which works. Follow the directions, they are toxic for the most part. The best solution is to trade your holed hood for a low pipe hood, this site might be a good place to start. There are skilled professionals that can weld in metal and make it like new minus the hole but it will be less than authentic, and cost more than the hood is worth. having a curved plate made to cover the hole, and using RTV to bond it to the surface will at least be flat, but not "farm show class work". (at least it won't ruin the hood's value. Good refinishing JimN
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|