Farmall & IHC Tractors Discussion Board |
bolster seal on 350
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jerry davis on May 27, 2005 at 16:36:01 from (64.53.33.60):
I'm rebuilding the bolster on my 350 rowcrop and have allmost all the parts from caseih but one seal. the lower seal old pt nmumber is 364 468 R91 my local dealer has ordered is twice and both times it comes in with a too small seal. Does anyone have a national or napa number I can use? BTW dumb question time, after reading many posts on this subject, and looking at bob M's pictures, can anybody tell me the correct way to install the lower spacer and thrust bearing? Can't tell from parts breakdown and mine didn't even have some parts in it on teardown. New bearing has numbers on outside should it be installed rightside up or down. bottom spacer flat up or down Thanks Jerry
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|