Farmall & IHC Tractors Discussion Board |
Re: Anyone seen this setup on SM
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nat on May 19, 2005 at 14:31:35 from (64.80.110.40):
In Reply to: Anyone seen this setup on SM posted by Ty1 on May 19, 2005 at 09:39:34:
Should be a fairly simple mystery to solve. Go in under the tractor's belly. I believe there's an access panel so you can get at the drive shaft for the belly pump. See if there's a drive shaft installed. No drive shaft? Then Aces is right. When the live pump was installed, it was plumbed so the lift-all's control valve could be used to run the hydraulics. You can safely connect the IN side of the triple-spool valve to the pressure side of the pump, and eliminate the belly reservoir. It only holds 3 quarts of oil or something like that anyway. Drive shaft? Then captaink is right. The pumps are working in tandem, though I don't really know what purpose that would serve.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|