Farmall & IHC Tractors Discussion Board |
Re: Farmall M front wheels
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by farmallhal on May 01, 2005 at 18:30:18 from (64.24.35.16):
In Reply to: Farmall M front wheels posted by John Zakar on April 30, 2005 at 14:49:35:
John, Per Guy Fay's IH Tractor Data Book he goes into the part numbering system used by IHC. The original part no. would have been 8284 and was later revised by the first design change to 8284A but still interchangeable with the earlier part no. Same thing when 8284A was revised again with another design change to 8284B. The new 8284B could still be used in place of a 8284 or 8284A. The hub in my M parts catalog is shown as a 8284DBX which is the 8284DB along with the necessary components to make a ready to install hub assembly consisting of the the hub, seals, retainers, etc. So to answer your question, they can be used together by engineering design and if they couldn't a totally new part no. would have been created to replace the earlier numbers with a tractor serial no. established for the change to the new hub part no. I believe these design revisions were to the hub casting for ease of production or additional strength. I hope this information is what you were looking for. Hal
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|