Farmall & IHC Tractors Discussion Board |
CUB news again
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GNB on May 01, 2005 at 18:06:10 from (152.163.101.13):
I pulled the head again today and found bad news. The head must have a crack allowing water in the crankcase. The oil level was about 1/2 quart high and radiator was low about the same. After studying the head closley it appeared to have been repaired before above #1 cylinder. The #1 cylinder had water dropplets on top of it and water on top of some of the valves. I guess next step is to find a good head and maybe even pull the engine and take it to a machine shop to check the block? I guess I will try this, never tore an engine completley apart so what I cant make from the manuals I will be needing some help. I guess also the water could be entering around the pistons in the block also? The cub does not have sleeves so could it still have a crack in the bores for the pistons? Its funny this started as a cub that wouldnt start and look where I am now. Thanks again. GNB in SC
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|