Farmall & IHC Tractors Discussion Board |
49 Cub (threw the towel in today)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by GNB on April 30, 2005 at 19:43:31 from (64.12.117.13):
I have done all I know to do on this machine. I am learning but here goes the whole story. I had the head off to clean and replace pitted valves. I bought the tractor from a owner who left the tractor outside without a raincap and water went in engine. I did get the rascal very cheap. The head is all I have had off the tractor. I put all valves back in (4 new intake valves, exhaust valves were in excellent shape), head on with new gasket, torqued to spec. Followed all instuctions in manual, rebuilt carb, new plugs,new points,new coil. Getting good fire on all plugs. Timed the distibuter to point directly at #1 at TDC firing position, followed firing order from there to connect rest of plug wires. The tractor will not hit a lick period not even spraying starter fluid in carb. AS I crank it over with starter sounds like its in a slight bind at times when turning over. The battery is new by the way and is 6 volt. The only time I can get anything is if I switch the plug wires around and then it just spits through the carb and somtimes spits a small flame out of the carb. I can not although smell any gas on the plugs at all, which I would think I could as many times as I have turned the tractor over. The carb is getting fuel. I am probally going to carry her to someone down the road that works on lots of IH tractors. I hate to because I wanted to accomplish this job. Thanks for the past posts fellows. If any other Ideas please let me know. GNB
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|