|
Farmall & IHC Tractors Discussion Board |
Re: Check-Row Corn???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne Swenson on April 27, 2005 at 21:21:41 from (66.191.70.4):
In Reply to: Check-Row Corn??? posted by KenSWLA on April 27, 2005 at 20:16:59:
The planter was controlled by a check wire that had knots tied every so many inches. 28", 30", 32" etc. the wire came in large rolls that would stretch cross the field from side to side.
The farmer would roll the wire out on 1 side of the field and stretch it somewhat to take the kinks out tying it to a special stake on both sides of the field. The tractor or horse & planter were pointed in the proper direction and the wire was attached to the trip mechanism of the planter.
As the planter was pulled it dropped several kernels of corn in the planter shoe and all of them were dropped in one spot when the trip wire knot struck the mechanism. ....X....X....X....X
At the end of the field, the wire was disconnected and the planter was turned around; the wire was re-connected and away the planter went. With a horse pulling the planter, it was a very rhythmic clicking sound; harder to hear with a tractor.
Farmers were very careful to get the hills of corn in alignment so they could cross-cultivate (this was before chemicals).
Your farming ability was judged by the neighbors looking for a nice cross-checked field. It was also very pretty to look at.
I tried check planting 10 years ago and learned that I had a lot MORE to learn. Longer rows & more practice would have helped, I guess.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
