Farmall & IHC Tractors Discussion Board |
Re: Axle ratios, etc
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on April 26, 2005 at 15:57:46 from (66.163.134.177):
In Reply to: Axle ratios, etc posted by CNKS on April 26, 2005 at 13:54:15:
As far as the tranny temp goes, that can be solved with a monster tranny cooler. Some people also swear by a deep, finned aluminum tranny pan. For occasional towing, you'll never get back the cost of the gear change. Also, with changing the gears, there's a bit of technical knowledge and labor involved, and for best results, some special gauges are needed to set up the gears, especially in the IFS axle. If you're really intent on changing the gears, the ideal thing would be a swap of axles with someone wanting to go the other way.. Also, the engine computer may be happier with a different chip, if the axle ratio is changed. The speedometer will be "off", I forget the details of correcting that, it will probably require a DRAC module. So for occasional towing, adding a big cooler is a great idea, and changing the axle ratio is a somewhat difficult, costly option that will take a very long time to pay back.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|