Farmall & IHC Tractors Discussion Board |
Re: 3 pt. hitch woodsplitter, on an M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Roger WI on April 24, 2005 at 20:03:17 from (69.58.151.150):
In Reply to: 3 pt. hitch woodsplitter, on an M posted by brianh on April 24, 2005 at 14:16:10:
Brian, I had the same problem some years back with my Super H. I have a three point hitch and bought a log splitter. There are several issues with using the belly pump for a log splitter. First, the pressure is only about 800 - 900 psi which isn't enough to split tough logs, but it works fine on easier splitting logs like oak. The second problem is what you discribed. The return oil has to pass back to the resorvoir through the vent/fill pipe. I could never get the oil to not leak out as I am sure you need a vent or it will blow out something in the belly pump. What I did was removed my belly pump and drilled a hole in the top of the casting to create an alternate vent. Since I did that and sealed the fill pipe I have had no leaks or oil coming out anywhere. I ended up taking the pump off so I could remove all the drill and tap shavings. Wasn't an easy job, but the results were good. Roger
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|