Farmall & IHC Tractors Discussion Board |
Re: steering
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by janicholson on April 24, 2005 at 11:18:04 from (66.173.50.85):
In Reply to: Re: Derek Broerse posted by Derek Broerse on April 24, 2005 at 10:34:21:
On the issue of hard steering, from the posts so far one item has been overlooked. The issue of the greasing of the bolsters is critical. If, as stated, the fittings seem to be screwed into blind holes, they in effect are. extreamly old oxidized grease will collect bushing particles and harden into a plug that is impossible to grease through. Pull the fittings and use a small drill bit (in your fingers or pliers, not a drill motor) and pick out all the black solid crud in the hole. Even if you did force grease in the bearing the crud would be forced into the bearing, not good. Open your grease gun and pull the plunger back to the notch like you were changing the cartridge. pour about 30ml an ounce of engine oil down cartridge, and replace the pump w/o spilling the juice. Next raise the front end (needed in prep for axel repair anyway) and pump in the oil. This washes some of the dirt out (oil has solvents, detergents etc,) and continue till clean grease comes out of the shaft. Turning the steering can also help limber things up. I like Ford automotive specification graphite based chassis grease, it is slippery stuff, and hangs in journals better in my opinion. LOL JimN
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|