Farmall & IHC Tractors Discussion Board |
Farmall M---give me 150%!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by zooeyhall on April 18, 2005 at 11:42:09 from (204.26.68.3):
My brother-in-law is a mechanical engineer for "a large farm equipment manfacturer", specifically desigining for the ground drive systems on their combines. I had the transmission cover off my M this weekend, had to take out one of the bull pinions to replace the oil seal, and I noticed him looking curiously at the bearings, pinion gears, etc. He asked me what an M was rated for at the drawbar (the manual says 35 HP), and he pulled out his micrometer and started measuring bearing sizes, shaft sizes, transmission case thickness, etc. Did some figuring and he determined that my M trans and drive components were designed to stand an over-torque condition of 150% of drawbar HP. He told me that where he works, the standard is to design for 110% drawbar HP. My brother in law just couldn't get over it how well built my M was. Is he just pulling my leg? If he's on the level, then these older tractors ARE much better built than modern ones!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|