Farmall & IHC Tractors Discussion Board |
Re: Burned up Super M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by magman on April 15, 2005 at 09:44:44 from (152.163.101.13):
In Reply to: Re: Burned up Super M posted by ChadS on April 15, 2005 at 08:07:11:
Yes Chad Gotch Ya on that,Right now I would love to go to 4 and 1/8 but every penny I have is going in to this H motor. I was able to pick up a real nice C169 Cam shaft on ebay last week for her. So I guess I am all set there I got about $50.00 into the cam and gear.And dont know where the next penny is coming from for the next set of parts. I would love to get the pistons from you for that but am waiting for some extra cash for those parts. Right now I have got the block and head checked and cleaned,and crank turned 0.20 under and the cam bearings installed and cam bought. Got a long ways to go . It might just take a year or two to complete with the money situation. OH WELL You do what you can. Have Fun with your Super I am going to try and post a pic of my family shortly. JON
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|