Farmall & IHC Tractors Discussion Board |
Re: Power-Adjusted Rear Wheels
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by janicholson on April 13, 2005 at 08:37:21 from (199.17.6.175):
In Reply to: Power-Adjusted Rear Wheels posted by iester on April 12, 2005 at 18:18:51:
The hind sight would be to mark the position, and count flats on the jacks as they are loosened. To get there from here, screw all jacks down, then tighten all one turn at a time till they are just long enough to allow the jacks to begin to push on the spiral rails. (choose the location you want the wheel to be in when done so that there are minimum marks on your new paint) Then, with the axle jacked enough for the tire to clear the ground, place a jack stand or other stout object very close to the tire and "C" clamp a piece of welding rod (or stiff wire) to the stand so that the tip of the rod is about 3mm (1/8") away from the rim outer most edge. Hand spin the assembly and adjust opposite groups of jacks higher and lower until radial runout is less than a #2 pencil lead width. Axial runout (wobble) is less critical and depends on creative positioning of the jacks along the rails by tapping them in the appropriate direction. This takes time but works! JimN
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|