Farmall & IHC Tractors Discussion Board |
Message to Hugh McKay
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Poindexter on April 03, 2005 at 17:46:53 from (67.63.131.7):
Dear Hugh: I have a bog disc that I cannot get my 140 to lift high enough to clear the ground when traveling. The disc originally came with a 100. The blades are about 20 inches; thus the fast hitch point is extremely high. The only way I can get the disc high enough is to loosen the set collar and pull the control lever and let the control rod back and then put a pair of vice grips behind the compression spring to shorten the control rod. The control rod is anchored in the front in the position nearest the driver's seat and at the back in the upper hole in the rock shaft. However, changing these two positions, I don't believe will shorten the control rod enough to get a clearance. Is there any way to correct the problem without using the vice grips? I have the depth adjustment link in to raise the fast hitch. Thank you for any assistance you can give me.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|